CCNA Quiz – Newmont Mining #2

Select the network address that is part of RFC 1918 private assigned address space?

Select the IP address that is publicly assigned from an ISP?

What transport protocol is connection-oriented?

What IOS command enables IPv6 packet forwarding on a Cisco router?

What IP addresses are not in the same subnet?

What statements correctly describe Cisco switch VLAN 1? (select three)

VLAN 10 is assigned as the native VLAN to switch-1. What happens when frames are sent to neighbor switch-2 that has a default configuration?

What IOS command will initially allow only VLAN 11 across a trunk for a switch that has a default configuration?

What is required to negotiate dynamic trunking between switches?

What is the purpose of a LACP channel group?

The following is an OSPF route from a routing table. What is the administrative distance?

O 192.168.12.8/30 [110/128] via 192.168.12.5, 00:35:36, Serial0/0

EIGRP, OSPF and RIPv2 are advertising routes to the same destination. What route is installed based on the following routing table information?

EIGRP = [90/1252335]

OSPF = [110/10]

RIPv2 = [120/3]

Based on the routing table shown below, when the router receives a packet with destination IP address 192.168.1.65, what is the next hop address?

router# show ip route

Codes: C – connected, S – static, R – RIP, M – mobile, B – BGP

D – EIGRP, EX – EIGRP external, O – OSPF, IA – OSPF inter area

N1 – OSPF NSSA external type 1, N2 – OSPF NSSA external type 2

E1 – OSPF external type 1, E2 – OSPF external type 2

o – ODR,  – candidate default

Gateway of last resort is 172.33.1.1 to network 0.0.0.0

192.168.1.0/24 is variably subnetted, 4 subnets, 4 masks

C       192.168.1.1/24 is directly connected, GigabitEthernet0/0

S       192.168.1.128/25 [1/0] via 192.168.2.1

S       192.168.1.64/26 [1/0] via 192.168.2.2

S       192.168.1.32/27 [1/0] via 192.168.2.3

S       10.254.254.254/32 [1/0] via 192.168.2.4

S      0.0.0.0/0 [1/0] via 172.33.1.1

What route is installed in the routing table to destination 192.168.1.0/27 when routes are advertised from the following sources?

What two statements are correct concerning static routing?

What IOS command advertises a local default route to all connected neighbors?

What is NTP stratum?

What SNMP traps generated from the Cisco device are logged when the following IOS command is configured? (select four)

device(config)# logging trap 4

What statement does NOT correctly describe Syslog server?

What last statement is required for proper IPv6 operation when deploying multiple ACL deny statements?

What is the only extended ACL that will NOT deny client access to web-based applications on a server?

What command enables VTY lines with local authentication?

What is not a component of Multi-Factor Authentication (MFA)?

What configuration management tool is well-suited to quick automation tasks ?

What is the default encoding standard for JSON?

What feature most correctly describes wireless SSID?

What three channels are non-overlapping in 2.4 GHz frequency band? (choose 3)

What command displays IP parameters on a Windows host?

What interface errors are caused by duplex mismatch?

What are two components of a Virtual Machine (VM)?

What is the number assigned to the switch management VLAN?

What is the default number assigned to a native VLAN?

What DTP mode supports negotiation of access mode and trunk mode interfaces?

What port type for a switch interface has lowest cost to the root bridge?

How do you verify all trunk interfaces that are operational on a switch?

The following is an OSPF route entry from a routing table. What is the metric calculation?

O 192.168.12.8/30 [110/128] via 192.168.12.5, 00:35:36, Serial0/0

What route (prefix) is selected in the routing table for packets with destination IP address 192.168.1.1?

What attributes determine route and best path selection? (choose 3)

Refer to the network drawing. Select two commands so that when either are configured on router-1, would provide a static route to network 172.16.12.0/24 on router-3?

Refer to the network topology drawing. Select the correct IOS command to configure a floating (backup) static route on router-1 to network address 192.168.3.0/24?

After network convergence has occurred, what standard OSPF packets are sent at regular intervals between routers?

What port number or keyword is assignable within an extended ACL to permit or deny HTTP?

What IOS command will configure the local username admin with privileged EXEC mode access and password cisconet?

What global IOS command is used to configure username admin with highest privilege level access and secret password cisconet?

What are three examples of solutions for physical access security?

Select three network overlay components?

How does Cisco DNA enable automation? (select two)

When does a router discard a packet? (select the best answer)

Refer to the network drawing. What route when configured on router-1 forwards all traffic destined for the internet to router-2?

What is the purpose of OSPF hello packets? (select two)